UNIPAK jointing compound is a grey, high-viscosity, paste jointing compound consisting of a saponified fatty acid, natural minerals, high grade paraffin oils and water. All the substances of the contents are permitted as additives to foodstuffs and the like.

APPLICATION: 

UNIPAK jointing compound is applied together with flax/hemp, for the sealing of threaded pipe joints on potable water systems, heating systems and low pressure steam systems. (max. 140°C and 8 bar).

TECHNICAL PROPERTIES: 

UNIPAK jointing compound applied together with flax/hemp provides 100% tight threaded pipe joints as well as UNIPAK facilitates connection and future disconnection of the joints. Application of UNIPAK jointing compound - contrary to e.g. thread seal tape - also provides a large adjusting flexibility as the pipe joints remain tight when loosened.

DIRECTIONS:

 Flax/hemp should be applied evenly and tightly to the thread in the direction of inclination of the thread. Then the entire packed thread should be applied an adequate quantity of UNIPAK jointing compound in an even layer, after which assembling can be carried out straight away and installations be put into service. Wipe away odd jointing compound with a cloth or the like.

TESTS: 

UNIPAK jointing compound's technical suitability has been repeatedly subjected to tests by the Danish Technological Institute. By this process it was proved that threaded joints properly sealed with flax/hemp and UNIPAK can remain tight up to 140°C and 8 bar. Tests also proved that UNIPAK jointing compound does not have an influence on water quality.

MULTIPAK is a grey, non-drying jointing compound on the basis of pure paraffinoil and fillers such as talc and chalk.

APPLICATION:

MULTIPAK is applied together with flax/hemp, for the sealing of threaded joints on pipe systems for POTABLE WATER, HEATING, NATURAL GAS, gas and butane. Also suitable for low pressure steam and compressed air.

TECHNICAL PROPERTIES:

MULTIPAK is approved for use in connection with potable water and all three gas families.
MULTIPAK ensures sealed joints and makes later dismantling easier as the jointing compound never dries up.
MULTIPAK is clean and pleasant to work with and economic to use.

DIRECTIONS:

Stirring MULTIPAK before use. Clean the thread. Apply an even layer of MULTIPAK to the thread. Then flax/hemp is  applied evenly and tightly to the thread in the direction of inclination. Finally the packed thread is covered with an even layer of MULTIPAK, after which assembling can be carried out straight away. Wipe away odd jointing compound with a cloth or the like.

APPROVAL:

MULTIPAK jointing compound is approved for POTABLE WATER and GAS in accordance with DIN 30660 and EN 751-2

PAKOL is a reddish brown, liquid, shellac-based jointing compound.

APPLICATION: 

PAKOL is applied together with flax/hemp for the sealing of threaded pipe joints on installations for petrol, oil, gas etc. (Not approved for gas).

LIMITATIONS OF APPLICATION:

PAKOL can be dissolved by perchlorethylen and ethanol.

TECHNICAL PROPERTIES:

PAKOL and flax/hemp provide completely sound joints with all types of threaded joints and for all smooth flange connections.. PAKOL retains tight seals under · HIGH PRSSURE (max. 30 bar) · TEMPERATURE FLUCTUATIONS (on gas applications max. 80*C) · VIBRATIONS.

DIRECTIONS: 

1. Clean the threads carefully for dirt and oil. 
2. Shake PAKOL well before use. 
3. Apply a layer of PAKOL on the unpacked/naked thread. 
4. Apply flax/hemp evenly and tightly to the thread. 
5. Apply PAKOL in an even layer to the packed thread. 
6. Let PAKOL dry a few minutes (until the jointing compound seems dull) before assembling. 
7. The installations should dry a couple of hours before putting into service. 
8. Be careful about good ventilation while working. Clean the brush in methylated spirits after using and close the lid tightly.

IMPORTANT: 

Pipe systems for diesel, FUEL OIL and other light types of oil must dry 24 hours before putting into service.

TESTS:

PAKOL's efficiency is thoroughly tested by the Danish technological Institute. Copy of the test rapport can be send for.

STORAGE: 

PAKOL must be stored in a tightly sealed container in a dry place.